DIY tutorial: 2005 series 1 automatic Mazda RX8 ECU/PCM replacement and programming using vxdiag vcx nano ford/mazda scanner.
For this you will need:
current car pcm
VCM II or vxdiag vcx nano mazda (the one i use)
Mazda IDS (download software on website Download area)
incode by outcode app (Play Store Link FREE)
a used or new replacement pcm
2 key fobs
plug in the vcx nano tool to the obdii port under the steering wheel
Open iDS and select start new session>all other
it will read your pcm and recognise your vehicle
if you have dsc select yes
advanced keyless entry > select correct option for you
check if details are correct and then continue
enter odometer reading if you want to (not required)
select module programming
select programable module installation > pcm
set ignition to on
set ignition back to off when prompted
when this prompt comes up unplug your pcm and plug in the replacement
take off the cover and undo all the bolts holding the pcm down. disconnect the air tubes at the front of the pcm
unplug these 4 connectors on the back of the pcm
set ignition to on
set ignition back to off when prompted
Mazda iDS will rewrite the data on the new pcm from your old one
set ignition back to on
set ignition to off again
programming complete. if you cannot crank your car now you will have to run the pats function.
go to body>security>PATS
follow on screen instructions then set ignition to on
select ignition key code erase and reprogram
download incode by outcode on google play store
check that vin is correct before continuing
this page has the OUTCODE you need. put that code into the incode by outcode app then press next when the app gives you an incode
put that outcode into the incode by outcode app and get your incode
type in incode provided by app
if it worked you get this screen
After this page its pretty simple. just follow on screen instructions until complete then you will have a working rx8 with a new pcm installed.
Done.