VXDIAG VCX NANO Ford Tested Working as a J2534 Passthru Device

I purchased a VXDIAG VCX Nano for Ford and Mazda vehicles back in 2019, I must say that I was skeptical of the product but decided to give it a try.

After a week of use I was very impressed. I found the vx nano can be used as a J2534 Pass-Thru device.

It does get recognized by the OEM J2534 software so i am going to show you two programs that i used one for Nissan and one for Kia.

Vxdiag Vcx Nano Ford Passthru Test 1

I have plugged it over here and it is plugged into the usb.

We’ll go over to Nissan (Nissan J2534 ECU Reprogramming Software)
i also have the FJDS bt that one you need a license.

with the Nissan we can actually get through it.
when you download the vx manager basically it shows up as a j2534
We select VXDIAG device
we will go next and then it read it as a j2534 passthru device as you see right here supplier allscanner

We don’t have a Nissan to test. But the vcx nano ford device can be recognized by the Nissan program.
Vxdiag Vcx Nano Ford Passthru Test 3

Vxdiag Vcx Nano Ford Passthru Test 4

Vxdiag Vcx Nano Ford Passthru Test 5

Vxdiag Vcx Nano Ford Passthru Test 6

Vxdiag Vcx Nano Ford Passthru Test 7

We also tested it on Kia program
Run J2534 KMA program
the program require to enable network connection
check the power switch and cable connection of the passthru device
select VXDIAG-J2534
initialization of passthru device

Vxdiag Vcx Nano Ford Passthru Test 8

Vxdiag Vcx Nano Ford Passthru Test 9

Vxdiag Vcx Nano Ford Passthru Test 10

Vxdiag Vcx Nano Ford Passthru Test 11

We do have a Kia car for test.  Will upload feedback soon.