Land rover L359 2010 RDCM Programming with VXDIAG JLR SDD

How to: program Rear Differential Control Module (RDCM) on a Land rover L359 New Freelander 2010 using VXDIAG Multi Tool for JLR SDD.

 

Preparation:

You need to connect vehicle with an extra power supply to make sure voltage is no less than 12.5V.  Do strictly follow every IGN ON/OFF operation.

 

Procedure:

Connect VXDIAG multi tool with vehicle via OBD socket

Run VXDIAG SDD software

vxdiag-jlr-sdd-rear-control-module-1

Auto detect vehicle informaiton

Select Service Functions

vxdiag-jlr-sdd-rear-control-module-2

Scan all modules available

Go to Recommendation tab

vxdiag-jlr-sdd-rear-control-module-3

Select Rear differential control module and press RUN 

Accept license agreement

Turn ignition switch to ON position

vxdiag-jlr-sdd-rear-control-module-4

Current voltage: 14V. VXDIAG JLR SDD will refuse to work if voltage lower than 12.5V.

Turn OFF ignition

Turn ON ignition

vxdiag-jlr-sdd-rear-control-module-5

Progress report, press tick mark to continue

vxdiag-jlr-sdd-rear-control-module-6

Check and update Rear differential control module by pressing tick mark

Module initializating

Turn OFF ignition

Turn ON ignition

vxdiag-jlr-sdd-rear-control-module-8

VIN learning routine

Turn OFF ignition

Turn ON ignition

vxdiag-jlr-sdd-rear-control-module-9

Clear ALL DTCs

Turn OFF ignition

Turn ON ignition

Rear differential control module programming success with JLR SDD.

 

http://www.vxdiagshop.com